Quantity One (1) used Sullivan/Palatek Portable Rotary Screw Air Compressor Model-#D450-Q6CA S/N-70583.
The compressor will produce 450CFM @ 125 PSIG, it is powered by a CAT diesel engine Model-#3056. The compressor was originally put into service in 1999 and only has approx 600 Hours on it. The compressor features a five (5) gauge instrument cluster (Hour meter, fuel gauge, discharge air pressure gauge, engine water temp gauge, engine oil pressure gauge) it also has an alternator warning light, load less starting, ether start.
Tires are good and the compressor runs good (it starts a little hard). This compressor new today costs over $30,000.00!!
Price on this unit-$8,500.00 (Subject to prior Sales)
FOB- Omaha, NE No freight is included
Terms- Cash, Wire Transfer or Certified Check
Warranty- Sold “As Is” No warranty expressed or implied
Quantity One (1) used Ingersoll Rand 50HP rotary screw air compressor Model-#SSR-EP50SE S/N-#G6289U97286. The compressor is air-cooled, 200/3/60 voltage, it will produce 194Cfm @ 125 PSIG. It comes with a full low sound enclosure, Air-cooled after cooler mounted and plumbed, full voltage starter mounted and wired. It has an Ingersoll Rand “Intellisys” solid state controller. Unit was in good operating condition when removed from service.
Price-$4,000.00 (FOB Omaha)
Sold As IS No warranty expressed or implied
Price is FOB Omaha, NE no freight is included
Terms- cash, certified check or wire transfer
Quantity One (1) New (DEMO) Sullair High Efficiency Refrigerated Compressed Air Dryer Model-#RN-50-AC-115/1/60. The dryer is air-cooled, 115/1/60 voltage. It will dry 50 CFM of compressed air to a +38 Degree F pressure dew point based on standard CAGI ratings; (100 Deg F Ambient, 100 Deg F Inlet Compressed Air Temp, 100% RH and 100 PSIG Inlet Compressed Air Pressure) This Sullair dryer features an advanced 3-1 counter current variable flow heat exchanger module that encompasses the air to air heat exchanger, the refrigerant to air heat exchanger and a separation chamber that utilizes a stainless steel multi stage demister. This water separation chamber allows the dryer to have a minimal pressure drop which is typically less than a pound of pressure drop (every two pounds of pressure drop robs you of 1% of your air compressors power). The RN series dryer has an environmentally friendly refrigerant; R-134A, high efficiency refrigerant compressor, electronic timer drain,
Fan cycle switch to shut condenser fan(s) off when not required, condensers are oversized for hot compressor room conditions, dew point indicator, on/off switch and light, Easy to remove side panels, all service items and service points are located to the side for easy serviceability and a FIVE (5) Year Warranty that covers the 3 in 1 heat exchanger module, the refrigerant compressor and the condenser (Optional Sullair pre-filter must be installed to validate the 5 year warranty). The quoted price includes all standard equipment as outlined in the attached support documents.
Terms- Cash Credit Card, Certified Check, wire transfer
Quantity One (1) ICP 5Hp High Efficiency Reciprocating Air Compressor Model-#ICP-B51V64-230/1/60-Elite. The compressor is air-cooled, 230/1/60 voltage, it will deliver 19CFM @ 175PSIG. The compressor is tank mounted on a 60 Gallon ASME coded vertical air receiver. It features a Solid cast iron pump with HD oversized Stainless Steel Disc and spring valves, it has a Centrifugal un-loader, the pump is designed for maximum output and HIGH volumetric efficiency (over 84% efficient) with a Low pump RPM pump, The pump features-oil sight glass, oil drain and fill on front of compressor pump, 80% duty cycle, two piece connecting rods with rod inserts, oil control ring & three compression rings for longer run life and improved efficiency, HD oversized taper roller bearings on both ends of the crankshaft for long life, wrist pin needle bearings, oversized built in inner cooler less likely to get damaged and sized for better inner cooling and most efficient volumetric efficiency. The ICP compressor package features a Heavy duty Premium Efficiency EPACT NEMA motor; this is typically 2% more efficient than a
high efficiency and it is a TRUE NEMA frame motor, V-belt drive system, OSHA style totally enclosed belt guard, HD steel enclosure intake filter silencers with 5 micron filter element, adjustable motor mounting, pressure switch, tank pressure gauge, ASME coded pressure relief valve. The is an "ELITE" Series and also includes- Full Voltage Starter Mounted & factory pre wired, Low Oil Monitor that is mounted and pre wired back to the starter so compressor will not operate if oil is low, and Vibro Tank Isolator Pads.
Terms- Cash Credit Card, Certified Check or Wire Transfer
Quantity (1) One NEW ICP Model# C130GEH34-GEN-WE Tank Mounted Gas Driven Air Compressor / Welder / Generator Combo Powered by Honda (13 Horse Power)!! S/N: The compressor will produce 19CFM at 175PSI utilizing a slow RPM compressor pump. Heavy Duty two stage solid cast iron pump. Disk and spring valves. Bearings on both ends of the crank shaft. Centrifugal unloader. Field replaceable needle bearings, and inserts on rods. Industrial grade gas engine. ASME coded & tested powder coated steel tank. V-Belt drive with two grove B width motor pulley. Access to compressor valves without compressor head removal. Pilot valve continuous operation. Fully enclosed OSHA approved belt guard mounted. Full saddle mounting feet instead of pegged mounting feet. The compressor is an "Elite" package and includes all standard equipment as well as these option- Air-cooled after-cooler mounted and plumbed, automatic tank drain mounted and plumbed, HD High Dust air intake filter silencer, vibro tank isolator pads. The generator is factory mounted, wired and plumbed on the compressor package and it will produce will produce 5500 Watts: 110/220 Volt Outlets, 41 Amps @ 120 Volt, 20 Amps @ 240 Volt. The welder is also factory mounted on the package & will allow 240 amps for welding. An on-board battery and key start is mounted and wired so not wiring is required to the vehicle.
Shipment- Stock (Subject to prior sale)
Terms – Cash, certified check, Credit Card or wire transfer